Home RF Components

RF & Microwave Components

Five families and eighteen component types that complete the RF chain, from the antenna port to the receiver and transmitter, designed and built in-house.

01

Amplifiers & Frequency Conversion

Gain stages and frequency translation for receive and transmit chains.

3D render of a low noise amplifier module

Low Noise Amplifiers (LNA)

Minimum noise figure with high gain at the front of receive chains, preserving system sensitivity.

3D render of a driver amplifier module

Driver Amplifiers

Linear medium-power gain that raises signal levels ahead of the final power stage.

3D render of a power amplifier on a finned heatsink

Power Amplifiers

High-output solid-state amplification for transmitters, with thermal design for continuous operation.

3D render of a double-balanced frequency mixer

Frequency Mixers

Double-balanced mixing for up- and down-conversion, with high LO-to-RF isolation.

02

Power Division, Coupling & Beamforming

Splitting, combining and sampling RF power, and forming beams for array antennas.

3D render of a 4-way power divider

Power Dividers

Wilkinson and reactive dividers and combiners with low loss and good port-to-port isolation.

3D render of a directional coupler with a terminated port

Directional Couplers

Sample forward or reflected power with defined coupling for monitoring, levelling and test.

3D render of a 90-degree hybrid coupler

Hybrid Couplers

90° and 180° hybrids for balanced amplifiers, I/Q networks and beamforming matrices.

03

Filters & Matching

Band definition and impedance transformation across the signal chain.

3D render of a cavity bandpass filter with tuning screws

Waveguide & Cavity Filters

High-Q cavity and waveguide filters for low insertion loss, sharp selectivity and high power handling.

3D render of an edge-coupled microstrip filter in a carrier

Microstrip & Lumped-Element RF Filters

Compact printed and lumped-element filters for low-profile modules and integrated assemblies.

3D render of a printed matching network with SMD components

Matching Networks

Impedance transformation for amplifiers, antennas and transitions, using printed stubs and lumped elements.

04

Control & Protection

Steering, routing and protecting RF signals.

3D render of a digital phase shifter module

Phase Shifters

Digitally controlled phase steps for beam steering in phased-array antennas.

3D render of an SP4T coaxial RF switch

RF Switches

Solid-state and electromechanical switches that route signals between paths, antennas and test ports.

3D render of an inline coaxial RF limiter

RF Limiters

Protect sensitive receivers and LNAs from damage by high-power incident signals.

3D render of a ferrite isolator

Isolators

Ferrite non-reciprocal devices that pass forward power and absorb reflections to protect sources.

05

Waveguide Components

Low-loss, high-power transmission hardware for microwave and millimetre-wave systems.

3D render of a flanged waveguide bend

Waveguide Bends

E-plane and H-plane bends for routing waveguide runs with minimal reflection.

3D render of a waveguide tee

Waveguide Tees

E-plane, H-plane and magic tees for power division, combining and duplexing.

3D render of a heatsinked waveguide termination

Waveguide Terminations

Matched loads that absorb power at the end of a waveguide line, heatsinked for high power.

Complete RF chain

Pair components with our antennas

From resonant elements to reflector systems and phased arrays, matched to the components on this page.

View Antennas

Have a specification in hand?

Send us your frequency band, gain or power level, interfaces and platform constraints. Our engineers will respond with a design approach.

Share Your Requirement